Information screen display
Brake warning display
This warning is displayed if you drive with the parking brake still applied. The warning lamp in the instrument cluster only illuminates when the parking brake is applied.
CAUTION
• If a vehicle is driven without releasing the parking brake, the brake will be overheated, resulting in ineffective braking and possible brake failure.
If this warning is displayed, release the parking brake.
When the ignition switch is turned to the “ON” position or the operation mode is put in ON, if the brake fluid is low, this warning is displayed.
The warning lamp in the instrument cluster also illuminates.
CAUTION
• If this warning stays illuminated and does not go out while driving, there is a danger of ineffective braking. In this case, immediately park your vehicle in a safe place and we recommend you to have it checked.
• If the brake warning display is displayed and the brake warning lamp and the ABS warning lamp are illuminated at the same time, the braking force distribution function will not operate, so the vehicle may be destabilised during sudden braking.
Avoid sudden braking and high-speed driving, stop the vehicle in a safe place, and we recommend you to have it checked.
• The vehicle should be brought to a halt in the following manner when brake performance has deteriorated.
• Depress the brake pedal harder than usual.
Even if the brake pedal moves down to the very end of its possible stroke, keep it pressed down hard.
• Should the brakes fail, use engine braking to reduce your speed and pull the parking brake lever.
Depress the brake pedal to operate the stop lamp to alert the vehicles behind you.
Charge warning display
If there is a fault with the charging system, the warning display is displayed on the information screen in the multi-information display. The warning lamp in the instrument cluster also illuminates.
CAUTION
• If the warning is displayed while the engine is running, immediately park your vehicle in a safe place and we recommend you to have it checked.
Oil pressure warning display
If the engine oil pressure drops while the engine is running, the warning display is displayed on the information screen in the multi-information display.
CAUTION
• If the vehicle is driven while the engine oil is low, or the oil level is normal but the warning is displayed, the engine may burn out and be damaged.
• If the warning is displayed while the engine is running, immediately park your vehicle in a safe place and check the engine oil level.
• If the warning is displayed while the engine oil level is normal, have it inspected.
Engine oil level warning display
When the ignition switch or the operation mode is in ON, if it is suspected that the engine oil level has increased excessively, the warning display is displayed on the information screen in the multi-information display.
CAUTION
• If this warning is displayed while driving, stop the vehicle in a safe place, turn off the engine, and check the engine oil level.
Refer to “Engine oil”.
NOTE
• Immediately have your vehicle checked by a MITSUBISHI MOTORS Authorized Service Point.
See also:
Position lamps (except for vehicles equipped with high intensity discharge headlamps)
1. For petrol-powered vehicles equipped with turbocharger, when replacing the
bulb on the left side, remove the bolt (A) holding down the relay box and move the
relay box towards the rear of the v ...
Spare wheel
Check the air pressure in the spare tyre weekly, making sure it is ready for
emergency use. Maintaining the spare wheel at the highest specified air pressure
will ensure that it can always be us ...
Alarm activation
The turn-signal lamps blink and the siren sounds for approximately 30 seconds.
Refer to “Alarm activation”.
Note
► The alarm will resume if unlawful actions are taken again, even if the ...