Volume and tone control panel
1- PWR (On-Off) switch
2- VOL (Volume control) knob
3- Display
4- SOUND (Sound control) switch
To adjust the volume
VOL (Volume control)
Turn the VOL knob clockwise to increase the volume;
anticlockwise to decrease the volume.
To adjust the tone
Press the SOUND switch to select: SUB PUNCH → TYPE → FIELD → BASS → MID → TREBLE → FADER → BALANCE → audio control mode OFF.
NOTE
• The SUB PUNCH can only be adjusted on vehicles with a premium sound system.
On vehicles without a premium sound system, when you press the SOUND switch, the display starts from TYPE.
QUICK ACCESS MODE
To access the sound customization features quickly, push and hold the SOUND switch, then turn the switch clockwise or anticlockwise to access your desired sound customization setting. Release the switch to adjust the setting.
HOLD MODE
If the SOUND switch is pushed and held for more than 2 seconds during the audio adjust mode, it will change to “Hold” mode. The selected audio mode will be held until the SOUND switch is pushed for more than 2 seconds again.
SUB PUNCH (Subwoofer volume control)
To select the desired subwoofer volume level.
TYPE (Acoustic characteristic selection)
1. Turn the SOUND switch to select the desired music type.
2. Press the SOUND switch to set the audio system to the selected music type.
FIELD (Sound field selection)
1. Turn the SOUND switch to select the desired sound field.
2. Press the SOUND switch to set the audio system to the selected sound field.
BASS (Bass tone control)
Turn the SOUND switch to select the desired bass tone.
MID (Midrange tone control)
Turn the SOUND switch to select the desired middle tone
TREBLE (Treble tone control)
Turn the SOUND switch to select the desired treble tone.
FADER (Front/Rear balance control)
Turn the SOUND switch to balance volume from the front and rear speakers.
BALANCE (Left/Right balance control)
Turn the SOUND switch to balance volume from the left and right speakers.
NOTE
• When set to 0, it will beep.
• When SUB PUNCH, TYPE or FIELD is changed, the sound will cut out briefly, but this does not indicate a malfunction.
• The audio control mode will shut off if either the radio or CD is operated, or if no adjustment is made within about 10 seconds.
See also:
Reversing sensor system operation indication lamp
In case there is a malfunction in the reversing sensor system, the reversing
sensor system operation indication lamp will blink and the warning buzzer will sound
for approximately 5 seconds. Even ...
To recline the seatback
Manual type
In order to recline the seatback, lean forward slightly, pull the seatback lock
lever up, and then lean backward to the desired position and release the lever.
The seatback will lock i ...
Parking
Parking on a slope
Fully engage the parking brake, and then move the gearshift lever to 1st (on
an uphill) or reverse (on a downhill) position on manual transmission vehicle. On
automatic transmi ...