Cigarette lighterCigarette lighter - For pleasant driving - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

The cigarette lighter can be used while the ignition switch or the operation mode is in ON or ACC.

1- Push all the way in.

1- Push all the way in.

The cigarette lighter will automatically return to its original position with a “click” when ready. Pull it out for use.

After use, insert the cigarette lighter to its original position in the socket.

• Do not leave the cigarette lighter removed from its socket, because the socket NOTE

• Do not leave the cigarette lighter removed from its socket, because the socket might become clogged by foreign material and be short-circuited.

• Do not touch the heating element or the cigarette lighter housing, hold CAUTION

• Do not touch the heating element or the cigarette lighter housing, hold the knob only to prevent burns.

• Do not allow children to operate or play with the cigarette lighter as burns may occur.

• Something is wrong with the cigarette lighter if it does not pop back out within approximately 30 seconds of being pushed in.

Pull it out and have the problem corrected at MITSUBISHI MOTORS Authorized Service Point.

• Do not use any electric appliance that is not approved by MITSUBISHI MOTORS. Doing so could damage the socket. If you used the cigarette lighter after damaging the socket, the cigarette lighter might pop out or fail to come out after being pushed in.

• When the cigarette lighter socket is used as a power source for an electric appliance, be sure that the electric appliance operates at 12 V and has an electric capacity of 120 W or less. In addition, long use of the electric appliance without running the engine may run down the battery.

    See also:

    Engine compartment
    Clean the engine compartment at the beginning and end of winter. Pay particular attention to flanges, crevices and peripheral parts where dust containing road chemicals and other corrosive materia ...

    Operating the system in automatic mode
    In normal conditions, use the system in the AUTO mode and follow these procedures: 1. Set the blower speed selection dial to the “AUTO” position. 2. Set the temperature control dial to the de ...

    Starting the engine (Petrol-powered vehicles)
    This vehicle is equipped with an electronically controlled fuel injection system which is automatically controlled. When starting the engine, do not depress the accelerator pedal. ...