Interior lamps
1- Luggage room lamp
2- Room lamp (rear)*
3- Map & room lamps (front) Sunshade illumination dimming control switch*
NOTE
• If you leave the lamps on without running the engine, you will run down the battery.
Before you leave the vehicle, make sure that the lamps are turned off.
Map & room lamps (front)
Room lamp
1- (DOOR)
The lamp illuminates when a door or the tailgate is opened. It goes off about 15 seconds after the door or tailgate is closed.
However, the lamp goes off immediately in the following cases:
• When the ignition switch is turned to the “ON” position or the operation mode is put in ON.
• When the central door lock function is used to lock the vehicle.
• When the remote control switch of the keyless entry system or the keyless operation system is used to lock the vehicle.
• If the vehicle is equipped with the keyless operation system, when the keyless operation function is used to lock the vehicle.
NOTE
• When the key was used to start the engine, if the key is removed while the doors and tailgate are closed, the lamp is illuminated and after about 15 seconds it goes off.
• When the keyless operation function was used to start the engine, if the operation mode is put in OFF while the doors and tailgate are closed, the lamp illuminates and after about 15 seconds it goes off.
• The time until the lamp goes off can be adjusted.
For details, please consult a MITSUBISHI MOTORS Authorized Service Point. On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment. Refer to the separate owner’s manual for details.
2- The lamp stays off regardless of whether the doors and tailgate are open or closed.
Map lamps
Regardless of the position of the room lamp switch, when the lens is pressed, the lamp on the side that was pressed will illuminate. Press the lens again to turn off the lamp.
Room lamp (rear)*
1- ( )
The lamp illuminates regardless of whether the doors and tailgate are open or closed.
2- (·)
The lamp illuminates when a door or the tailgate is opened. It goes off about 15 seconds after the door or tailgate is closed.
However, the lamp goes off immediately in the following cases:
• When the ignition switch is turned to the “ON” position or the operation mode
is put in ON.
• When the central door lock function is used to lock the vehicle.
• When the remote control switch of the keyless entry system or the keyless operation
system is used to lock the vehicle.
• If the vehicle is equipped with the keyless operation system, when the keyless
operation function is used to lock the vehicle.
NOTE
• When the key was used to start the engine, if the key is removed while the doors and tailgate are closed, the lamp is illuminated and after about 15 seconds it goes off.
• When the keyless operation function was used to start the engine, if the operation mode is put in OFF while the doors and tailgate are closed, the lamp illuminates and after about 15 seconds it goes off.
• The time until the lamp goes off can be adjusted.
For details, please consult a MITSUBISHI MOTORS Authorized Service Point. On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment. Refer to the separate owner’s manual for details.
3- ()
The lamp goes off regardless of whether the doors and tailgate are open or closed.
Luggage room lamp
The lamp illuminates when the tailgate is opened, and goes out when the tailgate is closed.
Sunshade illumination dimming control switch*
The brightness of the sunshade illumination can be adjusted to 3 different levels when the ignition switch or the operation mode is in ON or ACC.
Each time you press the switch, the brightness switches in sequence from high → middle → low → off → high.
NOTE
• The brightness can be adjusted even when the ignition switch is in the “LOCK” position or the operation mode is in OFF, provided that the sunshade illumination is turned on.
Sunshade illumination*
The sunshade illumination turns on when the ignition switch or the operation mode is in ON or ACC.
NOTE
• The sunshade illumination does not turn on if the sunshade illumination dimming control switch is off.
Refer to “Sunshade illumination dimming control switch”.
When the sunshade illumination is turned on, it will go off about 15 seconds after the following operation is performed.
• When the key was used to start the engine, the key is removed while the doors and tailgate are closed.
• For vehicles equipped with the keyless operation system, the operation mode is put in OFF while the engine is running and the doors and the tailgate are closed.
NOTE
• The time until the sunshade illumination goes off can be adjusted. If it is adjusted, the time until the room & map lamps go off is also adjusted automatically at the same time.
For details, consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
The sunshade illumination also turns on when a door or the tailgate is opened, and goes off 15 seconds after the door or the tailgate is closed, even when the engine switch is in the “LOCK” position or the operation mode is in OFF.
However, the sunshade illumination immediately goes off in the following cases:
• When the central door lock function is used to lock the vehicle.
• When the remote control switch of the keyless entry system or the keyless operation system is used to lock the vehicle.
• If the vehicle is equipped with the keyless operation system, when the keyless operation function is used to lock the vehicle.
NOTE
• The sunshade illumination does not turn on if the sunshade illumination dimming control switch is off.
• The time until the sunshade illumination goes off can be adjusted. If it is adjusted, the time until the room & map lamps go off is also adjusted automatically at the same time.
For details, consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
Interior lamp*1 auto-cutout function
*1 Interior lamps, including the room and map lamps • If any of the interior lamps are left switched on with the ignition switch is in the “LOCK” position or the operation mode is in OFF, it goes off automatically after approximately 30 minutes.
• The lamps will illuminate again after they automatically go off if the ignition switch or the engine switch is operated, or if the keyless entry system or keyless operation system is operated,
NOTE
• The interior lamp auto cut-out function can be deactivated. The time until the lamps automatically go off can be adjusted. For details and support, consult your nearest MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
See also:
USB input terminal
You can connect your USB memory device or iPod to play music files stored in
the USB memory device or iPod.
The following explains how to connect and remove a USB memory device or iPod.
Refer to t ...
Replacing tyres and wheels
Caution
► Avoid using different size tyres from the one listed and the combined use
of different types of tyres, as this can affect driving safety.
Refer to “Tyres and wheels”.
► ...
Operating a music player connected via Bluetooth®
For the operation of a music player connected via Bluetooth®, refer to “To play
tracks from a Bluetooth ® device”. ...