If the vehicle breaks down
If the vehicle breaks down on the road, move it to the shoulder and turn on the hazard warning flashers and set up a warning triangle, flashing lamp, etc.
Refer to “Hazard warning flasher switch”.
If the engine stops/fails
Vehicle operation and control are affected if the engine stops.
Before moving the vehicle to a safe area, be aware of the following:
• The brake booster becomes inoperative and the pedal effort will increase. Press down the brake pedal harder than usual.
• Since the power steering system is no longer operative, the steering wheel feels heavy when turning it.
See also:
ACD control mode switch
When the ignition switch is set to the “ON” position, operate the AWC switch
to change the control mode.
Each time the switch is pushed, the control mode changes in the order “TARMAC”
...
Aluminium wheels
1. Remove dirt using a sponge while sprinkling water on the wheel.
2. Use neutral detergent on any dirt that cannot be removed easily with water.
Rinse off the neutral detergent after washing the wh ...
Rear shelf panel (Hatchback)
To remove
1. Pull the knob and tilt the rear seat back slightly forward. 2. Slightly
lift up the front edge of the rear shelf. Slide the rear shelf rearward by tapping
it lightly at the right a ...