Position lamps

Remove the lamp socket by turning it anticlockwise, then pull out the bulb from the socket.
See also:
Twin Clutch SST control mode
When the ignition switch is set to the “ON” position, operate the Twin Clutch
SST control mode switch (A) to change the control mode.
When the engine is started, the control mode is automatic ...
Obstacle detection areas
The detection areas of the corner and back sensors are limited to those shown
in the illustration. Moreover, the sensors are unable to detect low or thin objects
or objects near the rear bumper. T ...
Windscreen washer
The windscreen washer can be operated with the ignition switch in the “ON” or
“ACC” position.
The washer fluid will be sprayed onto the windscreen by pulling the lever towards
you.
When ...
