Introduction of outside air
To introduce air into the vehicle during hot weather, set the air selection switch (A) to the outside position and set the temperature control dial to the position shown in the illustration. Be sure to set the temperature control dial all the way to the left. Select the desired blower speed.
NOTE
Turn the mode selection dial clockwise and air will flow to the leg area and the windscreen.
See also:
Emergency starting
If the engine cannot be started because the battery is weak or dead, the battery
from another vehicle can be used with jumper cables to start the engine.
WARNING
To start the engine by use of jump ...
Wheel condition
1- Location of tread wear indicator 2- Tread wear indicator
Check the tyres for cuts, cracks and other damage. Replace the tyres if there
are deep cuts or cracks. Also check each tyre for pieces ...
Installation of accessories
We recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
• The installation of accessories, optional parts, etc., should only be carried
out within the limits prescribed by law i ...